Generac GP6500 COsense

Generac GP6500 COsense is a portable generator from Generac, rated 6,500 running watts with 8,125 starting watts on gasoline, with 120/240V output.

General
Type portable
Fuel gasoline
Power output
Running watts (gas / LP for standby) 6500 W
Starting watts (gas) 8125 W
Performance
Runtime at 50% load (gas) 11.5 h
Fuel tank 7.9 gal
Electrical
Output voltage 120/240V
Transfer-switch-ready outlet 30 A
Features
Start type recoil
CO safety shutoff Yes
Engine
Engine displacement 389 cc
Physical
Weight 172 lb

What the numbers mean

Compare the Generac GP6500 COsense

Similar generators

Frequently asked questions

What can the Generac GP6500 COsense run during an outage?

With 6,500 running watts on its best fuel, the Generac GP6500 COsense covers a partial-home setup through a 30 A transfer switch or interlock: refrigerator, furnace, a well or sump pump, and lights, with load management for anything bigger. Add up your actual loads with a sizing worksheet — the bands here are rough guidance, not a load calculation.

How long does the Generac GP6500 COsense run on a tank of gas?

About 11.5 hours at 50% load on its 7.9-gallon tank, per the manufacturer's rating. At a lighter 25% load, figure roughly 18.4 hours (estimated — fuel burn does not scale linearly with load).

What does the Generac GP6500 COsense cost to run for a day?

Roughly $53 for 24 hours of continuous operation at about 50% load on gasoline, at national average fuel prices. The assumptions behind this estimate are documented on the methodology page; your fuel price and load change the figure.

Does the Generac GP6500 COsense have a CO safety shutoff?

Yes — the Generac GP6500 COsense has a built-in carbon monoxide sensor that shuts the engine down when CO accumulates around the unit. It is a backstop, not a substitute for running the generator outdoors at least 20 feet from the house.

What inlet does the Generac GP6500 COsense need to power a house?

A 30 A generator inlet (an L14-30 connection) wired to a transfer switch or interlock kit — an electrician's job that normally requires a permit. Never backfeed through a dryer or wall outlet.

Sources