Westinghouse WGen7500DF is a portable generator from Westinghouse, rated 7,500 running watts with 9,500 starting watts on gasoline (6,750 W on propane), measured at 72 dBA, with 120/240V output.
General
Type
portable
Fuel
gasoline, propane
Power output
Running watts (gas / LP for standby)
7500 W
Starting watts (gas)
9500 W
Running watts (propane)
6750 W
Starting watts (propane)
8550 W
Performance
Noise level
72 dBA
Fuel tank
6.6 gal
Electrical
Output voltage
120/240V
Transfer-switch-ready outlet
30 A
Features
Start type
remote electric
Engine
Engine displacement
420 cc
Physical
Weight
201 lb
What the numbers mean
At 7,500 running watts
on its best fuel, this unit covers a partial-home setup through a 30 A transfer switch or interlock: refrigerator, furnace, a well or sump pump, and lights, with load management for anything bigger.
Runs on gasoline, propane — expect lower output on propane (roughly
10%) and natural gas (roughly 20%) than on gasoline; the spec table shows the
published per-fuel ratings.
House hookup: pairs with a 30 A generator inlet (
L14-30) and a transfer switch or interlock
installed by an electrician.
What can the Westinghouse WGen7500DF run during an outage?
With 7,500 running watts on its best fuel, the Westinghouse WGen7500DF covers a partial-home setup through a 30 A transfer switch or interlock: refrigerator, furnace, a well or sump pump, and lights, with load management for anything bigger. Add up your actual loads with a sizing worksheet — the bands here are rough guidance, not a load calculation.
What inlet does the Westinghouse WGen7500DF need to power a house?
A 30 A generator inlet (an L14-30 connection) wired to a transfer switch or interlock kit — an electrician's job that normally requires a permit. Never backfeed through a dryer or wall outlet.
